 |
Did You Know?
You Get:
100% Free for Life
Technical Support:
Before you buy
AND
After you buy
We're here for you.
Contact Tech Support
|
|
|
|
Shop > X-10 Pro > PZZ01
|
X10 PRO 250Amp Coupler/Blocking Filter
|
|
|
|
 Enlarge Image
|
Installs at the electrical panel to couple up to three phases. Also prevents X10 command signals from entering or leaving the building, effectively isolating the residence. Recommended for ALL X10 PRO installations. This device CAN be retrofitted.
|
|
|
|
|
|
|
The X10 PRO 3-phase 250A Signal Blocking Coupler is designed to attenuate (at a rate of 30:1)
X10 power line carrier signals from crossing from one household to another via the AC wiring.
The coupler/blocker is installed between the meter and the breaker panel, using the Copper
Neutral between the two. The unit may be used in single, dual or three phase installations. For
best results a PZZ01 should be installed at both homes experiencing the signal crossings.
Unique features of the design include its ability to efficiently couple X10 signals between phases,
the elimination of any direct connections to the power company-side wiring and the elimination of
heavy current carrying inductors, resulting in a very compact design.
Note:Installation must be carried out by qualified electricians only. The main breaker must be
turned off during installation and the flter must be installed in a suitable workbox or equivalent
enclosure. Check local Electrical Codes in your area for any additional installation requirements.
A jumper on the PZZ01 is needed from L3 to L2 when installing into a split-phase panel.
Installing the 250A Filter
|
- Switch off the power at the main breaker panel.
- Install the filter into a suitable workbox or equivalent enclosure using the four mounting slots.
- Disconnect the neutral cable running between the meter and the breaker panel/fuse box. Pass
the cable through the channel in the filter and re-connect it. (Maximum 250 Amp Copper)
Note:If the cable is not long enough, use a new cable of the correct type and rating. Do not
attempt to extend the cable by joining it.The cable must be passed through the filter in the
correct direction as indicated by the label on the side of the filter.
- Connect the N terminal on the filter to neutral in the breaker panel using minimum 15A wire.
- Install a minimum 15A breaker or fuse in the breaker panel on phase 1 and connect it to the
filter terminal marked L1 using minimum 15A wire.
- Install a minimum 15A breaker/fuse to phases 2 and 3 as required and connect to terminals 2
and 3 on the filter.
- Check all wiring and switch on the main breaker.
|
|
|
|
|
|
|
|
|
|
The Smartest DIY Home Improvements
